Controller version v1.3 is almost finished …. Programm, pcb, sch, brd
Controller version v1.3 is almost finished …. Programm, pcb, sch, brd
Pagaminta 10 patobulinto valdiklio PCB, Jos yra Šiauliuose. Aprašymas čia.
Dėl stogo dangos keitimo sezonas baigtas anksčiau. Kitiems metams tas pats kolektorius (du trikampiai) bus sumontuotas ant žemės. Vamzdynas pailgės apie 10 metrų, bet pasvirimo kampas bus 45 laipsniai (bus galima reguliuoti) , plotas padidės iki 4 kv. m.
Tested the new controller v1.2 version of the program to work with the network module ENC28J60 intended for data storage server.
The program here- https://codebender.cc/sketch:37555
The server has to be installed emoncms program.
Čia galite pasiskaičiuoti kada atsipirks Jūsų saulės kolektorius lyginant kolektoriaus kainą su išlaidomis elektrai, kurią naudojate vandeniui šildyti.
19 April 2013. collector is filled with water.
There has been an improved solar control version. The program can write here. PCB is universal and can be adapted to the changing program of your needs. Arduino is the standard 5-key pad (A0) connector 16×2 LCD display (LCD LiquidCrystal (A5, 3, 4, 5, 6, 7)), the display backlight is turned on / off programmatically (D8), connect ENC28J60 network module (CS-D10 SI-D11, D12-SO, SCK-D13), three outputs DS18B20 sensors (D2, D9, A3). Relay connection for A1, A2. The controller is looks like :
There a new simple solar controller version. Changes: added 5 button keyboard, added connection for network module, added LCD backlight on / off.
More knowledge will be presented later.
Boiler heat exchanger made of 5 m 1/2 “section of corrugated stainless steel pipe. Between the inlet and outlet coolant at around 4 degrees difference.
2013.05.02
Already made a controller printed circuit board (PCB):